1150kW Natural Gas Generator 480V 600V Waukesha 7044GSI

New surplus 1150kW generator package with dual voltage capability (480V or 600V). Unit can run on either natural gas or propane. Ready to ship.

• Waukesha 7044GSI gas engine, EPA Certified, 1200 rpm, continuous duty w/engine driven radiator assembly, enrolled in Waukesha engine preservation program
• Kato Alternator, 1200KW, 6P6-3300, 6 Poles, 2 Bearing, 1200 rpm, 80 Deg C temp. rise, PMG, 600/480V dual Voltage, 0.8 PF, Renold coupling
• Waukesha Engine ECU & Auxiliary I/O Box
• Deep Sea 8610 Engine controller, start/stop/shutdown, sync, island, load share (other Deep Sea controllers) & utility parallel (adj. base load) modes of operation
• 50 gallon oil make-up system with level indication
• Inlet gas train with regulator, manual shutoff valve and solenoid, piped to outside of enclosure
• 3-way exhaust catalyst and industrial exhaust silencer with heat blanket and exhaust flexible connection, exhaust stack w/extension and rain cap, structural frame to support catalyst and silencer
• Engine skid recessed-mounted into working skid
• Non-slip diamond plate floor
• Base frame designed to accommodate drop over, weather resistant enclosure, lift-off frame, for (6) – point rig on/lift off from base/platform
• Removable lifting eyes
• Bolt-on connection to platform/base
• Two (2) single access doors
• One (1) double access door
• Spill Containment for engine coolant & oil, Incorporated into working platform
• Main circuit breaker, front access only through double doors on alternator end of genset, NEMA 3R rated, 2000AF insulated case circuit breaker, fixed mounted, 600/480VAC NEMA 3R, 65k AIC, UL891, LSIG trip, neutral sensor, 24VDC shunt trip, Form ‘C’ aux contacts, copper ground bus, metering CT’s and PT’s, open & close control by Deep Sea 8610 controller
• Cable connection, 600/480V, 2000A – alternator output to main breaker, protected in steel wire way
• Exterior cable connection, copper bus with NEMA pads/holes designed to accept customer cables and lugs, designed for cable entry from ground level, at side of enclosure near double doors
• 480V to 120/208V transformer
• 100A load center
• Interior lighting, receptacles, and cable tray, convenience receptacles – GFCI, (1) double socket each side of gen container, (1) near breaker/control cabinet
• DC emergency lighting each side of container, above access/escape doors with timer
• Exterior lighting – (2) elevated lights to maintain light at ground level, pre-wired and installed but shipped loose
• Light switches with weatherproof covers
• Flush mount emergency stop with break glass NEMA 3R, shipped with extra contact blocks
• SENS battery charger,  battery box with spill containment